A rotten-egg smell that shows up only at the hot tap is one of the more confusing water problems in a St. Charles home. The first question is simple: is the smell coming from the water supply, or from something that happens after the water enters the house? Answering that before you buy any treatment saves time and keeps you from fixing the wrong thing.
Compare the cold and hot taps
Start with a side-by-side check. Run the cold tap in the kitchen for a minute, then smell the water in a clean glass. Repeat at the hot tap. Then check a bathroom sink and an outdoor spigot if you have one.
- Smell in both hot and cold water: the problem is likely in the supply, whether that is the municipal line or a private well.
- Smell only at the hot tap: the problem is most likely in the water heater or the hot water piping.
- Smell at only one fixture: check the drain, the trap, and the aerator before blaming the water.
What can cause the smell
Hydrogen sulfide is a gas with a rotten-egg smell. In a water heater, sulfate-reducing bacteria can grow in the tank, and a magnesium anode rod can react with sulfate in the water and produce the gas. Warm tank conditions can encourage that growth, so a heater set high or left idle for long periods may smell more than one that is used steadily.
Private wells can also carry hydrogen sulfide from the source. Some wells near St. Charles draw on the Missouri River alluvial aquifer, where natural sulfur compounds can reach the water. A well smell often shows up at both the hot and cold taps. Municipal water in St. Charles is disinfected with chlorine, and that is a different smell from rotten eggs, so a sulfur odor in city water usually traces back to the plumbing in the house.
Check the water heater
Look at the anode rod, which is usually mounted at the top of the tank. Rod material matters, so ask a licensed plumber to identify what is installed and whether it has been used up. A plumber can also flush the tank, check the temperature setting, and look for sediment buildup. Hard water in St. Charles can add scale to the tank, and scale can make a flush less effective over time, so note whether the heater has been serviced before.
Test before you filter
Once you know the smell is in the supply, test before choosing treatment. Hydrogen sulfide can be checked with a field kit or a laboratory test. For a private well, a certified lab can test for sulfide and bacteria together. Collect the sample from the cold tap closest to where the water enters the house, before any filter or softener, and ask the lab to record the collection point.
Filter options and their limits
Activated carbon can reduce some odors, but it does not treat a water heater that is producing the smell. Sulfide in well water is usually handled by a system chosen from the test results, not by a general-purpose filter. A whole-house filter will not fix a heater problem, and a heater flush will not fix a supply problem. Match the treatment to the source you actually found.
Steps to take this week
- Run the cold and hot taps and note which one has the smell.
- Check a second fixture and an outdoor spigot to see whether the smell is everywhere.
- Have the water heater and anode rod inspected by a licensed plumber.
- If the cold water also smells, collect a sample for a laboratory test before choosing equipment.
- Choose a filter only after you know where the smell begins.